| Model number: |
GL-PMG-500A |
| Rated Rotatoin Speed(RPM) |
450 |
| Rated Output Power(W) |
500 |
| Outer frame material |
High standard Aluminium alloy with TF/T6 heat treatment
(TF/T6 full heat treatment for increasing the performance of aluminium alloy as follows. Heat 4-12 hours at 525-545 degrees Celsius, quench with hot water, and precipitation heat treatment for 8-12 hours at 155-175 degrees Celsius.) |
| Outer
frame finish |
Aluminium
surface is anodised then power painted for anti-corrosion
protection |
| Shaft
material |
High
standard Stainless Steel |
| Shaft
bearing |
High standard NSK 6207DDUC3(Front) NSK C(Rear) |
| Weight(Kgs) |
14.4 |
| Rotor inertia (Kg.m2): |
0.006 |
| Fasteners
(nuts and bolts) |
High
standard Stainless Steel |
| Lamination
stack |
High
specification cold-rolled Steel |
| Windings
temperature rating |
180
degrees Celsius |
| Magnet
material |
NdFeB
(Neodymium Iron Boron) |
| Magnets
temperature rating |
Rated at 150 degree Celsius |
| Generator
configuration |
3
Phase star connected AC output |
| Safety |
Capable
of withstand short term shorting of the windings
for braking effect at rated rotation speed. Class
1 electrical safety rated for prevention of electrical
shocks. |
| Starting torque(NM) |
<0.5 |
| Phase resistance(ohms) |
0.4 |
Recified DC Current at
Rated Output(A) |
20 |
| Requied Torque at Rated Power(NM) |
14.8 |
| Output Wire Square Section(mm2) |
4 |
| Output Wire Length(mm) |
600 |
| Download: |
|
